POLARIS 330cc Engine
330 Engine Oil Level Check
To check the oil level:
1.
Set machine on a level surface.
2.
Place the transmission in neutral.
3.
Lock the parking brake.
Start the engine and allow it to idle for 30 seconds.
Turn the engine off.
The oil dipstick / fill hole is located inside the left front
fender of the ATV.
7.
Remove the dipstick and wipe it clean.
8.
Reinstall the dipstick completely.
9.
Remove the dipstick an check the oil level.
10. Add oil as needed to bring the level between the minimum
and maximum marks. Do not overfill.
11. Reinstall the dipstick.
330 Engine Oil and Filter Change
1.
Set machine on a level surface.
2.
Place the transmission in neutral.
3.
Lock the parking brake.
4.
Start the engine. Allow it to idle for two to three minutes
until the engine is warm.
5.
Turn the engine off.
6.
Clean the area around the drain plug.
7.
Place a drain pan under the vehicle.
8.
Remove the drain plug and completely drain the engine oil.
9.
Reinstall the drain plug with a new sealing washer.
NOTE: The sealing surfaces on the drain plug and
crankcase should be clean and free of burrs, nicks
or scratches.
10. Torque to specification.
Drain Plug Torque: 14 ft. Ibs. (19 Nm)
11. Place towels under the oil filter.
12. Using an oil filter wrench, turn the filter counter-clockwise
to remove it.
13. Clean the filter sealing area on the engine.
14. Lubricate the O-ring on the new oil filter with clean oil.
Check to make sure the O-ring is in good condition.
15. Install the new oil filter. Turn clock-wise an additional
1/2 turn by hand after the filter contacts the sealing surface.
16. Remove dipstick and fill crankcase with the recommended
amount of engine oil.
Recommended Engine Oil:
PS-4 PLUS 2W-50
Synthetic 4-Cycle Engine Oil
(PN 2876244) (Quart)
Capacity:
1.9 qts. (1.8 I) (with oil cooler)
1.7 qts. (1.6 I) (oil change only)
17. Reinstall the dipstick.
18. Start the engine and allow it to idle for two minutes.
19. Turn off the engine. Check for oil leaks.
20. Verify the oil level. Add oil as needed to bring the level
between the min. and max. marks. Do not overfill.
21. Discard used oil and filter properly.